HYDM70-110V Hydraulic Hose Saw

HYDM70-110V Clean-Cuts Hydraulic Hose for up to 1-1/4 inch x 4 wire hose.

Clean-Cuts hydraulic hose cutting system is break-through technology using a toothed blade, cutting with the backs of
each tooth, so the blade does not take a kerf. The saw bends the hose into the blade spreading the cut edges to avoid
burning and smoking.

New Improved Clean-Cuts Method

With the Clean-Cuts hydraulic hose saws the hose is positioned across two pins (A) and moved into the blade (C) by a feed foot (B) using a pulldown handle for better leverage on heavy hose. The feed motion causes the hose to stretch at the point of contact with the blade, allowing it to separate as it is cut (see image at below). This separation allows the hose to pass clear of the saw blade with NO friction, NO heating and NO DEBRIS! A vacuum hose (not shown) is attached to a vacuum port (D) to remove any tiny amount of debris or smoke during cutting. Improved safety using a 110V on/ off switch (E) with a magnetic contactor. When power is lost, the saw will not turn back on independently.

 

Features & Benefits

• Cleaner Cuts
• Safer Cuts
• No Smoke
• 1-1/2 HP
• 110 VAC (1 Phase)
• 60 Cycle
• 17** Amp
• 3,430 RPM
• Includes: One 7″ OD x .093 THK X 3/4″ arbor