Ridgid 50767 258 2-1/2-8 inch Pipe Cutter

Power Pipe Cutter / Model 258
21⁄2" to 8" Diameter Pipe
The RIDGID Model 258 Power Pipe Cutter cuts 21⁄2" to 8" schedule 10*/40
steel pipe, galvanized pipe, rigid conduit etc. at the job site or in the shop.
Powered by the RIDGID No. 700 Power Drive, the 258 is a displacement
cutter that provides square cuts. The operator controls the feeding rate
by pumping the hydraulic foot pump throughout the operation. A square
cut with minimal burr on either 21' or nipple lengths of pipe is achieved
quickly** without abrasive dust, sparks, or open flame. Also, the RIDGID
Pipe Roller for Beveling can be used to rotate the pipe while a second
operator uses a grinder to bevel the pipe. Some of the 258 advantages are:
• Square cut 21' or nipple lengths of pipe without effort.
• Easily cuts by displacing instead of removing pipe material.
• No abrasive dust, dangerous sparks, or open flame.
• Quickly cuts steel pipe with minimal burr.
• Great for cutting pipe for groove joining.
• Heavy-duty design is perfect for field or shop use.
• Adaptable for beveling.

Specifications
• Cutting Capacity: Model 258 21/2" to 8" schedule.
• 10*/40 steel pipe.
• Model 700 Power Drive.
• Power Drive RPM: 33 (no load).
• Weight: 105 lbs. (excludes No. 700 Power Drive, see page 4.15).

Standard Equipment
• One (1) RIDGID 774 Square Drive Adapter.
• One (1) 81/2" HD Cutter Wheel Assembly.
• One (1) Hydraulic Ram and Foot Pump.
• Two (2) 21/2" to 12" Ball Transfer Pipe Supports.
*Use the thin cutter wheel for best results.
**Cutting time varies with pipe schedule and diameter.
Note: Models 258 and 258XL are not recommended to cut cast iron pipe.
For optimum wheel life always properly support the work piece with
pipe supports. (See pages 2.2 to 2.5)